Sentinel X300 System Cleanser 1Ltr

Product Information

Sentinel X300 Cleaner for New Systems should be circulated, preferably at normal operating temperature, with all valves open and the pump turned to maximum flow for a minimum period of 3 hours. To clean an older system in accordance with BS 7593, this product should be circulated (preferably at normal operating temperature, with all valves open and the pump turned to maximum flow) for a minimum period of 2 hours or until satisfactory performance is restored. Use in conjunction with a powerflushing device to achieve a more rapid clean.

Apply to: Restore circulation and effectiveness in systems older than six months that have a significant amount of corrosion debris causing poor circulation and cold spots. Prepare for the installation of new components. In this scenario, your customer may struggle to understand how the system could possibly need cleaning. New systems can easily succumb to debris during and after installation as a result of carelessness in the manufacture and installation processes. Recommended dosage: 1 litre of X800 is sufficient to treat a typical domestic system of up to 10 radiators. For maximum performance circulate from 1-24 hours.X800 is non-aggressive and can be left in the system over 24 hours, however this may cause debris to re-settle reducing effectiveness. In this scenario, the system may benefit from a manual flush using with X300. The system I’m dealing with is older than 6 months If a system has not been cleaned prior to use, all of the aforementioned issues for new systems will be present, with the installation debris causing issues and damage to the system.

For details of how to dose using the Rapid-Dose format of this product, please watch the Rapid-Dose video. If it is not possible to heat the water, the circulation time should be extended to at least 24 hours. After cleaning, the system should be drained and flushed until the water runs clear. On refilling, the system should be treated with Sentinel X100 Inhibitor or Sentinel X500 Inhibited Antifreeze. litre, 1 300ml aerosol or 1 275ml tube of Sentinel X400 High Performance Cleaner is sufficient to treat a typical domestic system of up to 10 radiators. Larger systems should be dosed with twice this amount. Apply to: Remove residual flux, grease, oil and manufacturing & installation debris in systems under six months old Why? Removes potentially damaging contaminants and restores system effectiveness, reducing future breakdowns and increasing system life. Unrivalled chemical technology reduces circulation time to just 1 hour.

How does it work? Contains a specialised dispersant to penetrate and lift sludge. Holds sludge in suspension ready for flushing. Why? Contamination from the manufacturing and installation processes can accelerate corrosion of new components. According to UK Building Regulations Part L Domestic Heating Compliance Guide, a central heating system should be thoroughly cleaned and flushed out before the installation of a new boiler. Sealed Systems: If the system is empty, add to any convenient point before filling. If full, use a Sentinel Dosing Vessel to inject via the filling loop or other access point. Recommended dosage: Ideal for pre-dosing, 1 litre of X400 is sufficient to treat a typical domestic system of up to 10 radiators. Circulate from 2 hours to 3 or 4 weeks depending on system fouling.Sentinel X800 Fast Acting Cleaner eliminates magnetite and limescale deposits from heat exchangers, radiators, underflor heating floors and pipework. It restores more uniform distribution of heat in existing installations, for a better heated home and reduced energy bills. How does it work? Acts as an emulsifier for oils and greases and a dispersant to lift and suspend particulate debris. Holds contamination in suspension ready for flushing.