Dewalt Laser Distance Meter DWHT77100 (0.2 to 30 m Range, Laser Class 2, Measurement Tolerance: +/- 3 mm / 10 m, Length, Areas, Volume & Pythagoras Measurements, Easy Operation)

Product Information

Total Tools reserve the right to change or withdraw free delivery at any time. Estimated Delivery Timeframes Press and hold the gear button (Figure A ) for 3 seconds. The measurement reference location icon (Figure C ) will flash on the display window. From the same point, aim the laser straight ahead toward the lowest point of the building or object (Figure I3).

Should you find one day that your DeWALT product needs replacement, or if it is of no further use to you, do not dispose of it with household waste. Make this product available for separate collection. Insert two AAA batteries, making sure to position the ‑ and + ends of each battery as noted inside the battery compartment (Figure E ). Position the tool at one end of the target and point the laser dot across the width. (Figure H ) shows where to position the tool if you are measuring from the top of the tool.) Point the laser (Figure A ) toward the wall or object whose distance you need to measure (Figure F). To reduce the risk of injury, user must read the Product User manual, Laser Safety manual, and Battery Safety information.Carefully read the Safety Instructions and Product Manual before using this product. The person responsible for the product must ensure that all users understand and adhere to these instructions. The tool will measure the distance from the bottom (Figure F ) or top (Figure F ) of the tool to the wall or object. At the bottom of the display window (Figure A ), view the current measurement (Figure C ), which will keep changing as you move the tool. DeWALT provides a facility for the collection and recycling of DeWALT products once they have reached the end of their working life. To take advantage of this service please return your product to any authorised repair agent who will collect them on our behalf. If INFO appears on the display window with a Code number, perform the corresponding Corrective Action. Code

Press the gear button (Figure A ) three times to show the indirect measurement height on the display window (Figure E ). Press On button (Figure A ) to measure the distance from the tool to the wall or object. Refer to Setup LDM to change the reference location and / or unit of measurement. The following label information is placed on your laser tool to inform you of the laser class for your convenience and safety.Once the current measurement is taken (the device is not in Continuous Measure mode), you can change the unit of measure from decimal ft (6.21 ft) to fractional ft (6'02"9/16), fractional ft to meters (1.894 m), meters to inches (74 9/16 in), or inches to decimal ft. The DWHT77100 tools emit a visible laser beam, as shown in Figure A . The laser beam emitted is Laser Class 2 per IEC 60825‑1. Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure. Battery Safety